Turnigy 9x programming software for computer?

er9x is the best known firmware. It has a superb range of features and is well supported by the community. Well worth trying out.
Post Reply
mfische
Posts: 1
Joined: Thu Nov 15, 2012 6:36 pm
Country: -

Turnigy 9x programming software for computer?

Post by mfische » Thu Nov 15, 2012 6:38 pm

Hi, I just got the Turnigy 9x transmitter, and I am so used to my old transmitter that had a software that I used on my laptop that I could go into my transmitter and change the throttle curve, pitch curve...etc for my RC heli. So far, from what I see, the Turnigy 9x can only be programmed via its already set up heli packages that you pick on the menu of the transmitter. what if I want to play around with the pitch and throttle curve?

Does anybody know if there is a software that I can hookup my Turnigy 9x to and play around with the rc heli stuff like throttle curve and pitch curve?


User avatar
Rob Thomson
Site Admin
Posts: 4542
Joined: Tue Dec 27, 2011 11:34 am
Country: United Kingdom
Location: Albury, Guildford
Contact:

Re: Turnigy 9x programming software for computer?

Post by Rob Thomson » Thu Nov 15, 2012 6:45 pm

If you upgrade from the stock firmware to either er9x or open9x you can :)
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!

User avatar
man-bis
Posts: 27
Joined: Tue Dec 27, 2011 9:10 pm
Country: -
Location: Russia

Re: Turnigy 9x programming software for computer?

Post by man-bis » Thu Nov 15, 2012 7:28 pm

mfische wrote:Does anybody know if there is a software that I can hookup my Turnigy 9x to and play around with the rc heli stuff like throttle curve and pitch curve?
You need a lot of reading the wiki. You will find all the answers. :mrgreen:

User avatar
Rob Thomson
Site Admin
Posts: 4542
Joined: Tue Dec 27, 2011 11:34 am
Country: United Kingdom
Location: Albury, Guildford
Contact:

Re: Turnigy 9x programming software for computer?

Post by Rob Thomson » Thu Nov 15, 2012 7:38 pm

Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!

sgofferj
Posts: 251
Joined: Tue Oct 09, 2012 5:11 pm
Country: -

Re: Turnigy 9x programming software for computer?

Post by sgofferj » Thu Nov 15, 2012 7:50 pm

Or do it like me - just buy a smartieparts board, install it, get companion9x, throw open9x on the TX and start fidling :-D .


Helle
Posts: 577
Joined: Sat Jul 21, 2012 7:08 am
Country: -

Re: Turnigy 9x programming software for computer?

Post by Helle » Fri Nov 16, 2012 8:23 am

Hy,

install companion9x and open9x or er9x and you can do it

Helle


Post Reply

Return to “er9x”