Output RSSI to a channel no cpercent"available

er9x is the best known firmware. It has a superb range of features and is well supported by the community. Well worth trying out.
Post Reply
claustro
Posts: 13
Joined: Mon Aug 27, 2012 8:29 am
Country: -

Output RSSI to a channel no cpercent"available

Post by claustro » Thu Sep 10, 2020 6:21 am

Hi all I am trying to send RSSI trough channel.
I followed this tutorial.
https://openrcforums.com/forum/viewtopi ... 8&p=123214
But I have 2 problems
1) I can't find percent as measure unit in scaler
2) even if I am able to read RSSI on the radio and followed the tutorial if I point cleanflight to use mapped channel as source for RSSI in the cleanflight configuration tab I still see RSSI 0% even if I clearly see fluctuating signal if I look at the the mapped channel in receiver tab

Thank you
Andrea


Inviato dal mio Mi 9T utilizzando Tapatalk



User avatar
MikeB
9x Developer
Posts: 17275
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: Output RSSI to a channel no cpercent

Post by MikeB » Thu Sep 10, 2020 10:31 pm

It seems only erskyTx has "pcent" as a unit available in a scaler, er9x does not.
I don't have any cleanflight hardware, so I can't help much. If the channel output is sending a mapped RSSI value, then it would seem the problem is in cleanflight.

Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

claustro
Posts: 13
Joined: Mon Aug 27, 2012 8:29 am
Country: -

Re: Output RSSI to a channel no cpercent

Post by claustro » Sun Sep 13, 2020 7:37 am

thank you for answering me


Post Reply

Return to “er9x”