ER9x - XJT - RR-XSR - Betaflight and Fport problem
Posted: Thu Aug 29, 2019 9:38 am
Hi, I've a Turnigy 9x modded with 9xtreme board. I flashed the XJT module with the last firmware and also the receiver Frsky R-XSR flashed with Fport firmware. I can bind the transmitter and the receiver, the telemetry works, but I can't see the movement of the stick inside Betaflight.
I also add the following instructions in CLI mode:
set serialrx_provider = FPORT
set serialrx_halfduplex = ON
set serialrx_inverted = ON
I also tried to move the XJT module on another 9x transmitter and also doesn't work.
I tried to use a different UART port on BF without results.
BF is the last veesion (4.05)
I don't know really where is the problem. Can you help me?
I also add the following instructions in CLI mode:
set serialrx_provider = FPORT
set serialrx_halfduplex = ON
set serialrx_inverted = ON
I also tried to move the XJT module on another 9x transmitter and also doesn't work.
I tried to use a different UART port on BF without results.
BF is the last veesion (4.05)
I don't know really where is the problem. Can you help me?