Changing Channel by switch
Changing Channel by switch
Hi guy... im trying to use a switch to change the channel use... for example...i wanna use stick channel 2 for other servo function...i wan to move a servo let say connect to channel 5 , when i flick a swicth...i can use ch 2 stick to move it without moving the existing ch 2 function totallly...being go through the forum cannot find anything...also try for few nite..cannot disable the existing channel function.
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Changing Channel by switch
Example using the RUD switch:
On channel 2, add a line at the end in the mixer:
R +100% CH2 switch(RUD)
Note that this is a "Replace" mix.
On channel 5 do the same thing, but with the opposite switch value:
R +100% CH5 switch(!RUD)
So, channel 2 looks (something) like:
+100% Ele
R +100% CH2 switch(RUD)
and channel 5:
+100% Ele
R +100% CH5 switch(!RUD)
Mike
On channel 2, add a line at the end in the mixer:
R +100% CH2 switch(RUD)
Note that this is a "Replace" mix.
On channel 5 do the same thing, but with the opposite switch value:
R +100% CH5 switch(!RUD)
So, channel 2 looks (something) like:
+100% Ele
R +100% CH2 switch(RUD)
and channel 5:
+100% Ele
R +100% CH5 switch(!RUD)
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!