I have a problem with connection for flysky i6x receiver and open pilot board
When I connect my receiver to the board is not showing any signal
Sent from my SM-G900T using Tapatalk
Help with receiver and cc3d open pilot board
-
- Posts: 1
- Joined: Sun Aug 05, 2018 1:21 am
- Country: -
-
- Posts: 183
- Joined: Sat Mar 29, 2014 10:44 pm
- Country: United States
- Location: Coral Springs, FL
Re: Help with receiver and cc3d open pilot board
I am not an expert on the i6x, and I have been working with the CC3D long time ago, but I can try to help you.
When you say "when I connect the RX to the FC it doesn't show any signal", what are referring to:
1) the RX showed as linked before connecting to the FC?
2) the RX is linked but does not transfers servo control to the FC?
3) the RX link LED is OFF, or goes OFF when connecting to the FC?
Are you connecting to the FC via PWM or SBus?
Please, clarify
When you say "when I connect the RX to the FC it doesn't show any signal", what are referring to:
1) the RX showed as linked before connecting to the FC?
2) the RX is linked but does not transfers servo control to the FC?
3) the RX link LED is OFF, or goes OFF when connecting to the FC?
Are you connecting to the FC via PWM or SBus?
Please, clarify
Richard