Help with receiver and cc3d open pilot board

er9x is the best known firmware. It has a superb range of features and is well supported by the community. Well worth trying out.
Post Reply
Francknivada
Posts: 1
Joined: Sun Aug 05, 2018 1:21 am
Country: -

Help with receiver and cc3d open pilot board

Post by Francknivada » Sun Aug 05, 2018 1:25 am

I have a problem with connection for flysky i6x receiver and open pilot board
When I connect my receiver to the board is not showing any signal

Sent from my SM-G900T using Tapatalk


Richard
Posts: 169
Joined: Sat Mar 29, 2014 10:44 pm
Country: United States
Location: Coral Springs, FL

Re: Help with receiver and cc3d open pilot board

Post by Richard » Mon Sep 17, 2018 3:28 pm

I am not an expert on the i6x, and I have been working with the CC3D long time ago, but I can try to help you.
When you say "when I connect the RX to the FC it doesn't show any signal", what are referring to:
1) the RX showed as linked before connecting to the FC?
2) the RX is linked but does not transfers servo control to the FC?
3) the RX link LED is OFF, or goes OFF when connecting to the FC?
Are you connecting to the FC via PWM or SBus?
Please, clarify
Richard

Post Reply

Return to “er9x”