er9x and multi-protocol telemetry mod

er9x is the best known firmware. It has a superb range of features and is well supported by the community. Well worth trying out.
efyzz
Posts: 8
Joined: Sun Nov 28, 2021 10:00 pm
Country: -

Re: er9x and multi-protocol telemetry mod

Post by efyzz » Wed Dec 01, 2021 8:53 pm

I read again what you've discussed with Timeless and set "Rate 50" to "T-Rate 50" in the protocol menu. Now I have RSSI and TSSI shown :)

Also the debug values are now 00AA and the second is upcounting.

I think it should have been working all the time with the correct settings :roll:

I'm not familar with telemetry yet, so I don't know what values I have to expect. But I think with the Telemetry menu I can configure the representation of all data ...? I have to read about this.

For me it seems to work. Or what else do I need?


efyzz
Posts: 8
Joined: Sun Nov 28, 2021 10:00 pm
Country: -

Re: er9x and multi-protocol telemetry mod

Post by efyzz » Thu Dec 02, 2021 10:11 pm

Ok, now I see what's missing. Here is information about the analog channels:
by defaut using FrSky Hub protocol (for example er9x): A1=RX voltage (set the ratio to 12.7 and adjust with offset), A2=battery voltage FS-CVT01 (set the ratio to 12.7 and adjust with offset) and RX&TX RSSI
So I should see some value for RX battery voltage at A1. But it is always 0.0V.

Any idea how to get this work?

User avatar
MikeB
9x Developer
Posts: 17712
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: er9x and multi-protocol telemetry mod

Post by MikeB » Sat Dec 04, 2021 10:15 am

There is a telemetry value "RxV", this is the receiver voltage and should be set if the telemetry is sending the value.
A1 is specific to FrSky, and is a copy of RxV (if RxV is being sent), unless there is a real A1 value sent.

Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

efyzz
Posts: 8
Joined: Sun Nov 28, 2021 10:00 pm
Country: -

Re: er9x and multi-protocol telemetry mod

Post by efyzz » Tue Dec 07, 2021 10:50 pm

Hi Mike,

Thanks again, it works! :D

I've ordered a FlySky FS-CVT01 voltage sensor. I'm curious whether that will work ;)

efyzz
Posts: 8
Joined: Sun Nov 28, 2021 10:00 pm
Country: -

Re: er9x and multi-protocol telemetry mod

Post by efyzz » Mon Apr 18, 2022 9:13 am

Hi,
Sorry for late reply. I just tried out the FS-CVT01 voltage sensor. Now I can see LiPo voltage with parameter FasV. It works! :)
Thanks again for your support!


Post Reply

Return to “er9x”