Helle, I wonder if this is possible and if so, how do i program it?
I would like some expo on my quadcopter when i do filming.
Is it possible to program the radio like if switch SA is in first position, there is no expo, but if the SA is in the midle position i have 20% expo on ail, rudder and yaw.
If the SA is in the third position i have 40% expo.
Is this possible to do?
Program expo on a switch?
Re: Program expo on a switch?
Yes.
Go to mixes.
Copy the existing mix AIL/ELE and padte it 3 times.
You now have four identical mixes.
(If you are using your radio to make these changes)
Open the top most mix.
Set Expo.
Locate and select Switch.
Move SA to the desired position.
Exit. Exit.
Done.
Do the same for the next two mixes.
The fourth and last mix is optional. I don't keep it myself but I watched a video where Scot Page kept it as a fall back (but I may be mistaken). Check out his play 2.0 and beyond on youtube. Also look for painless360.
Please test.
Go to mixes.
Copy the existing mix AIL/ELE and padte it 3 times.
You now have four identical mixes.
(If you are using your radio to make these changes)
Open the top most mix.
Set Expo.
Locate and select Switch.
Move SA to the desired position.
Exit. Exit.
Done.
Do the same for the next two mixes.
The fourth and last mix is optional. I don't keep it myself but I watched a video where Scot Page kept it as a fall back (but I may be mistaken). Check out his play 2.0 and beyond on youtube. Also look for painless360.
Please test.
Rav
http://hikeforhappiness.ca
http://hikeforhappiness.ca
Re: Program expo on a switch?
My explanition was not exactly what you asked. But you hopefully get the idea.
Repeat step for each channel/control surface.
Repeat step for each channel/control surface.
Rav
http://hikeforhappiness.ca
http://hikeforhappiness.ca