Binary with Mavlink extension for beta testing

openTx has introduced a range of new features, ideas and bling. It is fast becoming the firmware of choice for many users. openTx will run on ALL current hardware platforms, including the gruvin9x and sky9x boards. Work has already started to support the new FrSky X9D radio!
Post Reply
bertrand35
9x Developer
Posts: 2764
Joined: Fri Dec 30, 2011 11:11 pm
Country: -

Binary with Mavlink extension for beta testing

Post by bertrand35 » Sat Mar 24, 2012 7:52 am

Here it is. The code is ported from gv9x. Please tell-me if it works, I don't own the module to test myself...
Thanks,
Bertrand.
Attachments
open9x.hex
(164.56 KiB) Downloaded 213 times


User avatar
uphiearl
Posts: 46
Joined: Tue Dec 27, 2011 11:21 pm
Country: -
Location: Mountainair New Mexico

Re: Binary with Mavlink extension for beta testing

Post by uphiearl » Sat Mar 24, 2012 5:56 pm

Screen 1 INFOS is correct so 38kb is working. I see the APM2 boot up properly and get the heartbeat indication
Screen 2 does not display any data. all fields are 0
Screen 3 is getting proper data.
Earl

bertrand35
9x Developer
Posts: 2764
Joined: Fri Dec 30, 2011 11:11 pm
Country: -

Re: Binary with Mavlink extension for beta testing

Post by bertrand35 » Sat Mar 24, 2012 6:17 pm

So no GPS information, right?
Bertrand.

User avatar
uphiearl
Posts: 46
Joined: Tue Dec 27, 2011 11:21 pm
Country: -
Location: Mountainair New Mexico

Re: Binary with Mavlink extension for beta testing

Post by uphiearl » Sat Mar 24, 2012 6:25 pm

went back to gv9x109dump and all is ok.
btw...i did not notice a baud rate selection
earl

User avatar
uphiearl
Posts: 46
Joined: Tue Dec 27, 2011 11:21 pm
Country: -
Location: Mountainair New Mexico

Re: Binary with Mavlink extension for beta testing

Post by uphiearl » Sat Mar 24, 2012 6:27 pm

just no gps info. baud must be 38kb cause that is whay my xbees do.
earl


User avatar
uphiearl
Posts: 46
Joined: Tue Dec 27, 2011 11:21 pm
Country: -
Location: Mountainair New Mexico

Re: Binary with Mavlink extension for beta testing

Post by uphiearl » Sat Mar 24, 2012 6:32 pm

i would like to see the display screens more like my old stile with double character hight and 10 screens. easier to read at a glance.
earl
Here is old post
http://diydrones.com/profiles/blogs/tel ... -tx-screen
Attachments
eemcj9x030.JPG

bertrand35
9x Developer
Posts: 2764
Joined: Fri Dec 30, 2011 11:11 pm
Country: -

Re: Binary with Mavlink extension for beta testing

Post by bertrand35 » Sat Mar 24, 2012 7:19 pm

uphiearl wrote:just no gps info. baud must be 38kb cause that is whay my xbees do.
earl
Ah ok, good explanation, I didn't ported it ...
I will do next week then.
Bertrand.


Post Reply

Return to “openTx”