My radio master tx12 seems to communicate with opentx companion, and I updated the firmware.
But before and after the firmware update, I am noticing the same issue, when I read the models from the transmitter (that I've created in the transmitter) companion opens the file but only shows the models that are factory loaded on the transmitter not the ones I've created.
Then when I create a model in companion and push it to the transmitter it seems to work, no error msgs, but doesn't show on the transmitter. Transmitter still shows the default models plus the one I created there and DOES NOT show the new model I created in companion.
Companion v 2.3.11
I can read and write to the SD card through the cable so I know it's communicating.
Any help would be appreciated. If I can't get this figured out it's going to seriously limit the use of this radio..!
Open TX companion version:
TX 12 bootloader:
Tx12 firmware version?:
Conflicting information about firmware version from a different screen:
Models written from companion to tx12:
Models unchanged in TX 12:
Windows drivers:
Windows drivers with TX in bootloader mode:
I'm hoping there's a simple brainless answer to this LOL
I'm obviously a noob and have no idea what I'm doing....
but no one was born knowing this stuff everyone had to start somewhere! Any help will be appreciated!
If this is posted improperly I trust you will delete it ,reprimand me, and point me to the proper forum!
thanks
Open TX companion and radiomaster TX12
-
- Posts: 2
- Joined: Sat May 15, 2021 4:07 pm
- Country: -
-
- Posts: 2
- Joined: Sat May 15, 2021 4:07 pm
- Country: -
Re: Open TX companion and radiomaster TX12
Update what I figured out is that the radio master tx12 will connect to the companion but you can't upload model files you have to get the TX 16s
Re: Open TX companion and radiomaster TX12
You totally can.