Question about endpoints in openTx

openTx has introduced a range of new features, ideas and bling. It is fast becoming the firmware of choice for many users. openTx will run on ALL current hardware platforms, including the gruvin9x and sky9x boards. Work has already started to support the new FrSky X9D radio!
Post Reply
cbf123
Posts: 8
Joined: Thu Apr 15, 2021 5:47 pm
Country: -

Question about endpoints in openTx

Post by cbf123 »

Hi,

I'm coming from a Turnigy9x running the stock firmware, and I realized that they treat endpoints separately for each *input* so that if you mix two sticks together (when doing flaperons for example) you can exceed the configured endpoints and over-drive the servo.

From the openTx manual it appears that endpoints are treated properly as a limit on the output of a channel, but I thought I'd double-check.

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Question about endpoints in openTx

Post by Kilrah »

Correct.
Post Reply

Return to “openTx”