Page 1 of 1
AFHDS-2A telemetry
Posted: Fri Nov 13, 2020 9:17 am
by michel49
I just tried the AFHDS-2A iA6B Rx with my Horus/4in1 module/OTX 2.2.1.
I get RSSI and CVT01 but not the CAT01 sensor, what I can do ?
Thanks
MP
Re: AFHDS-2A telemetry
Posted: Fri Nov 13, 2020 12:20 pm
by Kilrah
Update everything, believe it was added at some point.
Re: AFHDS-2A telemetry
Posted: Sat Nov 14, 2020 9:14 am
by michel49
I have an issue to flash my X10: I have the usb logo on the screen but Companion tell me "not connected, driver not installed
very strange since I can read the models ...
Re: AFHDS-2A telemetry
Posted: Sat Nov 14, 2020 9:35 am
by Kilrah
To flash firmware you must be in bootloader mode or off, not on.
Re: AFHDS-2A telemetry
Posted: Sat Nov 14, 2020 12:26 pm
by michel49
I guess you tell "Tx off" ?
When I do that I see the transfer is instantly on the PC screen....but the FW remain the same (2.2.1)
I get the message
Filter on vendor = 0x0483 product = 0xdf11
More than one DFU capable USB device found, you might try `--list' and then disconnect all but one device
Re: AFHDS-2A telemetry
Posted: Sat Nov 14, 2020 2:26 pm
by michel49
OK, I changed the PC and now the Horus is flashed with the 2.3.10 FW but now it ask to update the multi-module, howto ? with Companion ? it is the 328 one.
Re: AFHDS-2A telemetry
Posted: Sat Nov 14, 2020 3:09 pm
by Kilrah
Re: AFHDS-2A telemetry
Posted: Tue Nov 17, 2020 2:27 pm
by michel49
OK updated both OTX and module (STM32)....but no CAT01 sensor...
Re: AFHDS-2A telemetry
Posted: Tue Nov 17, 2020 3:32 pm
by Kilrah
Re: AFHDS-2A telemetry
Posted: Tue Nov 17, 2020 4:35 pm
by michel49
Oupss, sorry Kilrah, I was wrong , I discovered the Alt sensor, and the atmospheric pressure!
Thanks for your help
MP