Hello, I'm stuck getting to work my r9m module with my 9xr pro and a 9rmm receiver.
I flashed the radio with open tx 2.2.3, with flex enabled, then tried to bind without success.
I then realized that my rf module is an lbt/EU version, so I flashed my radio without flex option, but can't bind either.
I also wanted to flash the RF module with last frsky firmware, but in opentx, when I go to radio setup, then SD-card, I see the .frk files, but I don't have any option for flashing it.
Does anybody can help me?
9xr pro and r9m module
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 9xr pro and r9m module
ErskyTx (was called ersky9x) firmware has the ability to flash modules over SPort.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: 9xr pro and r9m module
Ho man! You saved my day! I was enabled to flash both of r9m modules (tx and Rx) over the 9xr pro SPort after flashing it onto frsky firmware, I switched back to opentx then.
Then the bind worked!
Good old radio
Thank you very much, hope this will help someone later.
Then the bind worked!
Good old radio
Thank you very much, hope this will help someone later.