Radio setup : current calib

openTx has introduced a range of new features, ideas and bling. It is fast becoming the firmware of choice for many users. openTx will run on ALL current hardware platforms, including the gruvin9x and sky9x boards. Work has already started to support the new FrSky X9D radio!
Post Reply
laurent
Posts: 1
Joined: Tue Aug 08, 2017 1:04 pm
Country: France, Metropolitan

Radio setup : current calib

Post by laurent » Tue Sep 12, 2017 7:36 pm

Hello,

I'm using openTX 2.2.0 on a Turnigy 9XR pro. I would like to adjust the 'Current calib' value in the radio setup menu 7/9 Analogs.
I could not find advices for that.
I have measured the current consumption of the radio (about 95mA) with an ampmeter and I try to enter this value in the 'Current calib' field but this field allows to select values from 591 to 723, so it is not possible to select 95.

Where am I wrong ?
Is this 'Current calib' value something else than the current consumption of the transmitter ?

Thanks in advance


gweep
Posts: 2
Joined: Mon Sep 16, 2019 2:34 am
Country: -

Re: Radio setup : current calib

Post by gweep » Mon Sep 16, 2019 4:22 am

Did you ever figure this out? I just posted the same question.

Post Reply

Return to “openTx”