Page 1 of 1

MiniHub+ - S.Port Telemetry Hub for Frsky Radios

Posted: Sun Aug 06, 2017 5:41 pm
by ckleanth
MiniHub+ - S.Port Telemetry Hub for Frsky Radios

I predominantly fly gasoline engine powered planes so it is important to me to use a device that work with the standard Tachometer leads from most gasoline engine ignitions. In addition monitor onboard voltage and engine temperatures.

This is what the new MiniHub+ (for FrSky/Taranis/Horus) does. It works with the standard Tachometer leads from most gasoline engine ignitions. The ignition system has conditioned the signal and it is easily used for the MiniHub+'s RPM header.

The MiniHub+ has also two temperature ports (you will need the FrSky thermistors FrSky TEMS-01) and three voltage inputs (0 to 5v, currently you will need the frsky voltage step down circuit FrSky FBVS to measure up to 5S LiPo battery).

The MiniHub+2/4 (can be used for multi engines) and to use two devices daisy chained together it requires OpenTX 2.1+ due to telemetry sensor ID assignment)

For more information please visit the following page.

https://www.rcgroups.com/forums/showthr ... sky-Radios

Re: MiniHub+ - Telemetry Hub for Frsky Radios running OpenTX

Posted: Sun Aug 06, 2017 7:53 pm
by MikeB
Why only for openTx? If it uses the SPort, why won't it work with ersky9x?

Mike.

Re: MiniHub+ - Telemetry Hub for Frsky Radios running OpenTX

Posted: Mon Aug 07, 2017 8:17 am
by ckleanth
MikeB wrote:
Sun Aug 06, 2017 7:53 pm
Why only for openTx? If it uses the SPort, why won't it work with ersky9x?

Mike.
not tested it mike. It should but I'm not using ersky9x. Can I send you one to try?

Re: MiniHub+ - Telemetry Hub for Frsky Radios running OpenTX

Posted: Mon Aug 07, 2017 8:42 am
by MikeB
If you can spare one, I'll test it out.

Mike.

Re: MiniHub+ - Telemetry Hub for Frsky Radios running OpenTX

Posted: Mon Aug 07, 2017 8:49 am
by ckleanth
MikeB wrote:
Mon Aug 07, 2017 8:42 am
If you can spare one, I'll test it out.

Mike.
Pm me your address mate. I will make one and send to you