FrSky XJT module. Is it dead?
Posted: Thu Dec 19, 2019 2:50 pm
I've had an XJT module in a TH9x with an AR9x board for a long time. Recently the XJT stopped working. When I power up the radio the red and green LEDs on the module are both on steady.
I cannot put the module into bind mode.
I have tested this module in a QX7 and a Jumper T12 with the same results.
I have also flashed the latest firmware. The flash was successful, but the module refuses to function.
Is there any hope, or do I need to replace it?
TIA..
I cannot put the module into bind mode.
I have tested this module in a QX7 and a Jumper T12 with the same results.
I have also flashed the latest firmware. The flash was successful, but the module refuses to function.
Is there any hope, or do I need to replace it?
TIA..