FS-RM003 and FS-IA10B on Flysky TH9X and Turnigy 9X

Choosing an RF Module? What modules work? What is compatible with the 9x?
Post Reply
User avatar
Escrich
Posts: 12
Joined: Tue Feb 27, 2018 9:09 pm
Country: Spain
Location: Spain 28500

FS-RM003 and FS-IA10B on Flysky TH9X and Turnigy 9X

Post by Escrich » Wed Jun 19, 2019 5:48 pm

Dear all I have those two emitters, Flysky TH9X and Turnigy 9X, and of course the software ER9X from a couple of years ago, and I’m very happy about how them work, my problem starts when I want to increase the number of channels from 8 to 10, since now, in both emitters I was using the module FS-TM002 and as receivers the FS-R8B, (actually has a different name), then I bought the pair FS-RM003 and FS-IA10B, I can do the binding process, both leds on module and receiver alights correctly, but I have no answer in any channel manipulating joysticks, switches or pots, I change back to the old ones and again everything works, could be because of something related with AFHDS2, I was searched the menu, inside MULTI for AFHDS2 option, but after hundreds of tests I ‘m not able to move any servo, could you please give some help?


Thanks in advance.

Regards:
JMEC
Attachments
índice4.jpg
índice2.jpg
índice.jpg
IMG_5775.jpg
Trying to learn something and help the others


User avatar
MikeB
9x Developer
Posts: 17240
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: FS-RM003 and FS-IA10B on Flysky TH9X and Turnigy 9X

Post by MikeB » Thu Jun 20, 2019 2:49 pm

If that module will work at all, you will need to use PPM (not Multi). You will need to set this to 10 channels, but also extend the frame time from the default of 22.5mS. I suggest at least 26.5mS.
It is possible that module needs a PCM signal to work. While I have an idea what this might be, I don't have the hardware to investigate and develop this.

I think you may find a multiprotocol module, operating with MULTI protocol will support that receiver.

Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

AntonC
Posts: 2
Joined: Sat Sep 26, 2020 12:11 pm
Country: -

Re: FS-RM003 and FS-IA10B on Flysky TH9X and Turnigy 9X

Post by AntonC » Sat Sep 26, 2020 12:24 pm

You will need to set this to 10 channels, but also extend the frame time from the default of 22.5mS. I suggest at least 26.5mS.
also in my case change POS to NEG was required.


But some another question:
I also have th9x + rm0003 + ia10b and all of it work via PPM. But when I switch off the radio all channels just freeze the values (I expect at least THR should go down to minimum value)

Tried:
configure failsafe on radio with default firmware
rebind receiver with transmitter
due er9x doesn't have failsafe option, tried just switch radio off with er9x
set any THR value and press "update" button on receiver

all this moves didn't help. Does anybody know the solution?


Post Reply

Return to “RF MODULES”