Can't program both End Points

Programming your 9x using the stock firmware that comes with the radio. (Note. This is for the th9x, not the X9R)
Post Reply
romandesign
Posts: 14
Joined: Tue Aug 14, 2012 2:47 pm
Country: -
Location: Toronto
Contact:

Can't program both End Points

Post by romandesign »

I just received my 9x yesterday. There is something I can't figure out:

When I go to E.Points setting, there are two columns of percentage settings, but I can only go through one of the two percentages for every channel. When I click up or down buttons it jumps through one setting - usually just in the right column, but sometimes on the left (it happens on two channels in airplane configuration). So I can't edit both endpoints of any channel! What am I doing wrong? Or if it's a bug - is there a workaround???
Roman Bershadsky

web designer, composer
http://www.romandesign.ca - award-winning Toronto Web Design Studio
My music: http://www.moebiuscat.com - Moebius Cat - listen and download free

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Can't program both End Points

Post by Kilrah »

If you try to set the end points for aileron:
To set the left end point, move the aileron stick left, and edit with +/-. To edit the right side, move the stick right.
romandesign
Posts: 14
Joined: Tue Aug 14, 2012 2:47 pm
Country: -
Location: Toronto
Contact:

Re: Can't program both End Points

Post by romandesign »

Ha! It was that simple! I feel stupid. You are correct, it works fine. Thanks!
Roman Bershadsky

web designer, composer
http://www.romandesign.ca - award-winning Toronto Web Design Studio
My music: http://www.moebiuscat.com - Moebius Cat - listen and download free
twistngrip
Posts: 1
Joined: Fri Feb 08, 2013 8:37 pm
Country: -

Re: Can't program both End Points

Post by twistngrip »

Kilrah wrote:If you try to set the end points for aileron:
To set the left end point, move the aileron stick left, and edit with +/-. To edit the right side, move the stick right.

Thank you very much Kilrah, I'm just programming my new 9X and I was frustrated by this same issue. I was about to decide I had a bad unit. I'm really happy to have found this answer. Now I feel a lot better about my 9X.

Post Reply

Return to “stock firmware (fly sky th9x)”