THR AIL switch warning

Programing help and example for all firmwares based on thus's th9 firmware.
Post Reply
gordinir8
Posts: 15
Joined: Sun Aug 24, 2014 5:29 pm
Country: -

THR AIL switch warning

Post by gordinir8 » Sun Sep 07, 2014 10:34 pm

Ok every time i am turning my radio on i got THR AIL switch warning please reset etc.
I have er9x installed and all of my switches are in the position they are supposed to be before turning on my radio (all switches away from me)
I have used to that and every time i was just pressing any key to get rid the message instead of check for wrong switch position. In fact to get rid the message i must turn those switches to on.
The result was that today i crashed my quad two blocks away from me on a tent with 7-8 people under. Don't even want to think what could happened!!!
I have reed that others had the same problem but i couldn't find a solution

User avatar
MikeB
9x Developer
Posts: 15805
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: THR AIL switch warning

Post by MikeB » Sun Sep 07, 2014 10:59 pm

It sounds to me that you haven't set the "Default Sw" setting. This specifies the position you want the switches to be in when you switch on.
What revision of er9x do you have installed? The latest is r813.
The exact method used to set the "Default Sw", and where it is in the menus, depends on the revision you are using.

Mike.
ersky9x/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

gordinir8
Posts: 15
Joined: Sun Aug 24, 2014 5:29 pm
Country: -

Re: THR AIL switch warning

Post by gordinir8 » Mon Sep 08, 2014 7:21 am

Hi Mike, I am using er9x-r813 version. Ok I found it in general settings, default switch, you must choose first the position you want your switches to be and then press default switch button.
Thank you
Thomas

Post Reply

Return to “er9x / gruvin9x / th9 based firmwares”