DSM2 channel output order
- Mechcondrid
- Posts: 222
- Joined: Fri Dec 30, 2011 3:53 am
- Country: -
- Location: ledyard, connecticut, United States
- Contact:
Re: DSM2 channel output order
Okay I figured it out it's a problem with the regulator the regulator was bad apparently and it was only putting .438 volt it was get it was getting 9 volts directly from the battery so I'm off to the local electronic shop to get another set of regulators will report back when I get home
- Mechcondrid
- Posts: 222
- Joined: Fri Dec 30, 2011 3:53 am
- Country: -
- Location: ledyard, connecticut, United States
- Contact:
Re: DSM2 channel output order
ok just got back from flying (so yes it works now)
turns out the rev b x1txn board does NOT like er9x for some reason and the 3.3v reg was bad
long story short the hp6dsm module i think is the highest revision of the x1txn board we can use (rev c1) other wise it simply doesnt send any bind signal out for some reason it does receive the ppm signal i think as the module does power up it just wont bind
turns out the rev b x1txn board does NOT like er9x for some reason and the 3.3v reg was bad
long story short the hp6dsm module i think is the highest revision of the x1txn board we can use (rev c1) other wise it simply doesnt send any bind signal out for some reason it does receive the ppm signal i think as the module does power up it just wont bind
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: DSM2 channel output order
Hi,
Closing this thread down as it has gone way off the original topic.
I suggest posting any of the regulator and module questions in the hardware mods sub forum
viewforum.php?f=26
Closing this thread down as it has gone way off the original topic.
I suggest posting any of the regulator and module questions in the hardware mods sub forum
viewforum.php?f=26
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!