9X with RM-003 module

Programing help and example for all firmwares based on thus's th9 firmware.
Post Reply
Mallikarjun
Posts: 3
Joined: Wed Sep 09, 2020 4:17 am
Country: -

9X with RM-003 module

Post by Mallikarjun »

I am completely new to transmitter mods and i flashed my FLYSKY TH9x that came with flysky FS-RM003 AHFDS2A Module.
I have recently upgraded my firmware from stock flysky firmware to eR9x firmware and later realised that my FSia10B receiver binds with the transmitter but servos do not move at all
the protocol set was:

Proto PPM 10CH 300uS
PPM FrLen 26.5mSec
Polarity POS

Is there any er9x firmware version that supports this stock AHFDS2A protocol modules ?
if not where do i find the original flysky firmware so that i can revert back to my factory firmware and settings?

Please help,

thanks.

User avatar
amxcs
Posts: 37
Joined: Tue Jun 04, 2019 8:02 am
Country: -

Re: Er9x test versions

Post by amxcs »

Replace the module with a multi protocol JP4IN1 and everything will be fine.
User avatar
MikeB
9x Developer
Posts: 17990
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: Er9x test versions

Post by MikeB »

Try polarity NEG.

Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
Mallikarjun
Posts: 3
Joined: Wed Sep 09, 2020 4:17 am
Country: -

Re: Er9x test versions

Post by Mallikarjun »

MikeB wrote: Wed Sep 09, 2020 10:27 pm Try polarity NEG.

Mike
Thank you so much mike that worked for me with the following settings
Proto PPM 10CH 300uS
PPM FrLen 36.5mSec
Polarity NEG
Mallikarjun
Posts: 3
Joined: Wed Sep 09, 2020 4:17 am
Country: -

Re: Er9x test versions

Post by Mallikarjun »

Dear mike,
I have a ER9x firmware with flysky FS-RM003 AHFDS2A Module and FS-IA10B AHFDS 2A Receiver
Is it possible to get telemetry data like battery voltage, gps cordinates, Altitude etc using
I2C sensors connected to an arduino nano that can be connected to the I-BUS telemetry port on the FS-IA10B receiver

is this even possible if so how do i go about it ?
also forgive me if this is the wrong place to post this topic.

Thank you

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Er9x test versions

Post by Kilrah »

No, that module doesn't supply telemetry.

Post Reply

Return to “er9x / gruvin9x / th9 based firmwares”