Page 1 of 1
"Hold" in simulator
Posted: Mon Aug 24, 2015 10:47 am
by kalle123
Simple question. Hopefully
Set throttle on min (right stick) and have HOLD activated.
When closing and reopen the simulator, throttle stick is in middle position again.
Should that stick position not be saved? Throttle on -100%, when opening the simulator.
v2.0.17 is installed
Just curious - br KH
Re: "Hold" in simulator
Posted: Mon Aug 24, 2015 10:53 am
by Kilrah
What the Hold buttons do is disable the virtual "spring" on each stick.
Re: "Hold" in simulator
Posted: Mon Aug 24, 2015 12:12 pm
by kalle123
OK. A pressed HOLD Button is saved, but not the throttle stick position ....
Re: "Hold" in simulator
Posted: Mon Aug 24, 2015 3:29 pm
by kalle123
So the program remembers, that the centering spring is disabled, but not, that the throttle is down ...
Does not make sense
Re: "Hold" in simulator
Posted: Sat Aug 29, 2015 5:10 pm
by athertop
kalle123 wrote:So the program remembers, that the centering spring is disabled, but not, that the throttle is down ...
Does not make sense
I have always thought the same. This should maybe requested as an enhancement?
In open Tx 2 the companion shows s3 also but does not work well at all to simulate the 6pos switch.