Simple question. Hopefully
Set throttle on min (right stick) and have HOLD activated.
When closing and reopen the simulator, throttle stick is in middle position again.
Should that stick position not be saved? Throttle on -100%, when opening the simulator.
v2.0.17 is installed
Just curious - br KH
"Hold" in simulator
Re: "Hold" in simulator
What the Hold buttons do is disable the virtual "spring" on each stick.
Re: "Hold" in simulator
OK. A pressed HOLD Button is saved, but not the throttle stick position ....
Re: "Hold" in simulator
So the program remembers, that the centering spring is disabled, but not, that the throttle is down ...
Does not make sense
Does not make sense
Re: "Hold" in simulator
I have always thought the same. This should maybe requested as an enhancement?kalle123 wrote:So the program remembers, that the centering spring is disabled, but not, that the throttle is down ...
Does not make sense
In open Tx 2 the companion shows s3 also but does not work well at all to simulate the 6pos switch.