can anyone tell me if its possible to connect to the 9xrPRO with companion9x..
I either get a "-E- Board at91sam3s8-9xr not found" error or "Error: You need to specify one of -D or -U"
I know its a new radio, but I guess someone must have found a way to use companion9x with the PRO radio.
how to connect to a 9xrPRO
Re: how to connect to a 9xrPRO
if you want to use opentx, yes you will have to use companion. If you want to run the firmware the radio ship with, ersky9x then you will have to use eepskye.. With eepskye I am able to help you.. But I never used the Pro with companion or opentx.. things changed a lot since last time I used companion..
João
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
Re: how to connect to a 9xrPRO
Just use the bootlaoder as explained in your issue on github.
-
- Posts: 3
- Joined: Thu Jun 19, 2014 8:26 pm
- Country: -
Re: how to connect to a 9xrPRO
Hi Kilrah.. I saw your reply.. thanks alot..
For anyone reading this, you need to hold down the two horizontal trim tabs and power on the radio to enter the bootloader.
For anyone reading this, you need to hold down the two horizontal trim tabs and power on the radio to enter the bootloader.