Lost in flashing my ersky9x board
Lost in flashing my ersky9x board
It's been a while since I flashed my ersky9x board, and now I'm lost. Sam-ba 2.11 was installed already, and seems to connect to the ersky board (which reports as a gps camera in windows7/64). Now I really can't get companion9x to read the flash... What do I put into the "configure" / "avrdude location", "programmer" "mcu", "port", "extra arguments" ? I don't see any references to sam-ba...
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: Lost in flashing my ersky9x board
Change your profile in preferences to a sky9x board.
Sent from my GT-I9300 using Tapatalk 2
Sent from my GT-I9300 using Tapatalk 2
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
Re: Lost in flashing my ersky9x board
Yes of course, thank you. I actually checked these settings about ten times, but still thought that "opentx for 9x board" was right ... Changed it and everything works flawlessly agin.