Mode 1 stick assignment

General mods that are considered worth doing; regardless of the end firmware you use.
Post Reply
gijon
Posts: 2
Joined: Fri Dec 05, 2014 9:36 pm
Country: -

Mode 1 stick assignment

Post by gijon » Fri Dec 05, 2014 10:26 pm

I have my Turnigy 9x up to speed with the SmartieParts 2.4 board and the latest er9x flashware
Version:
SVN: er9x-r814
VERS: V1.394-Mike
DATE: 16.11.2014
TIME: 23:20:08

My transmitter is Mode 1 from factory. On the model screen, it shows:
Left side - THR
RUD
ELE
Right side - AIL
GEA
TRN
I would like to name them correctly. I have looked everywhere and cannot seem to find a solution
Any help from the gurus is good. I have been through the menus with no success and the er9x guide only states to change modes without any further explanation.

User avatar
MikeB
9x Developer
Posts: 15805
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: Mode 1 stick assignment

Post by MikeB » Fri Dec 05, 2014 10:48 pm

Those three names down each side are the switches, not the sticks. When a switch is turned ON, the switch name is highlighted.

Mike.
ersky9x/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

gijon
Posts: 2
Joined: Fri Dec 05, 2014 9:36 pm
Country: -

Re: Mode 1 stick assignment

Post by gijon » Sat Dec 06, 2014 12:09 am

Thanks...Mike.
That was simple...I should have known that.

Post Reply

Return to “Electronic Mods”