Slimming up the HK 3 and 6 channel Rx's for the 9x

[Ozzy]

A couple of my gliders do not have enough room for the HobbyKing HK-GT2R 3ch and HK-TR6A V2 6ch Rx's for use with my er9x Tx. I changed the standing up servo connectors to right angle, height with servo connector was 22mm, now it's 8.1mm (the width of the servo connector), here is a picture of the mod.

More pictures here, notice the ground pins are connected on the bottom of the PCb to save height:
http://wforacer.multiply.com/photos/alb ... nector-mod#

I also added 200uF (100 x2 ceramic) caps across servo power. I just need to finish it up with some shrink tubing.

Comments welcome.
Ozzy