taranis x9dplus parking sensor
Posted: Fri Sep 28, 2018 5:55 pm
Hi
I'm Angelo , I'm from Italy
I have a taranis x9dplus and 2 x8r receiver in parallel for 16 channel. I use this radio to programme an rc car 1/10 scale , in particular a land rover defender 110. I have seen different video on YouTube where a lot of guys simulate car parking sensor using arduino board , 1 ultrasonic sensor and 1 buzzer. in this way buzzer sound is proportional to the distance read from ultrasonic sensor.
My question is:
Is it possible to make the same without using arduino board? I have 1 ultrasonic sensor and 1 buzzer( the same of the video) , i wouldn't use arduino for this because it is a waste ... So I ask you if it is possible to programme the radio to make the same
I look forward to your response,
Best regards,
Angelo
I'm Angelo , I'm from Italy
I have a taranis x9dplus and 2 x8r receiver in parallel for 16 channel. I use this radio to programme an rc car 1/10 scale , in particular a land rover defender 110. I have seen different video on YouTube where a lot of guys simulate car parking sensor using arduino board , 1 ultrasonic sensor and 1 buzzer. in this way buzzer sound is proportional to the distance read from ultrasonic sensor.
My question is:
Is it possible to make the same without using arduino board? I have 1 ultrasonic sensor and 1 buzzer( the same of the video) , i wouldn't use arduino for this because it is a waste ... So I ask you if it is possible to programme the radio to make the same
I look forward to your response,
Best regards,
Angelo