I seem to have found a minor issue with the eePe simulator. I have a simple 4 channel setup on the first model in ER9x and after the maiden of the aircraft i imported the model configs back into eePe - which included a noticable amount of elevator trim. This all showed up as you'd expect it to under the Trim tab. However, after that i was playing around with some expo settings and went to check the result in the simulator and noticed that even with -100% throttle, the output was showing as -89%. I looked around a little more and noticed that the throttle trim was up in the simulator. I double checked the trim tab and that was showing trim was set on elevator not throttle (simulator showed no trim on elevator).
Probably worth noting that i'm using Mode 1 setup!
So it appears if eePe is set to mode 1 and you have a noticable amount of elevator trim, it shows up on the throttle channel when you're in the simulator.
Should be easy enough to verify.
Its has no real effect other than throwing a noob like me for a bit of a spin
