Multiprotocol module and 9XT, Telemetry not working
Posted: Sun Jan 01, 2017 5:37 pm
Mike, using my multi module with the 9XT, selected the frskyD protocol, telemetry COM1, inverted and not inverted. I don't get any telemetry.
On my PRO radio, selecting COM 1 and inverting it, I do receive the telemetry. Is there any special configuration I need to do when compiling the multi code in order to receive the telemetry on the 9XT? Or is there some hardware mod needed?
By the way, a bit off topic as this happens on the PRO, but when using the multi module with the frskyD protocol, when I turn the radio OFF with the receiver still ON, it starts vibrating until it turns OFF. If I turn the rx OFF first, the radio then shuts down normally. This happens only with the multi module, and not with the DJT. Perhaps it could be related to inverting COM1?? I can make a video of it if you want..
Thanks
João
On my PRO radio, selecting COM 1 and inverting it, I do receive the telemetry. Is there any special configuration I need to do when compiling the multi code in order to receive the telemetry on the 9XT? Or is there some hardware mod needed?
By the way, a bit off topic as this happens on the PRO, but when using the multi module with the frskyD protocol, when I turn the radio OFF with the receiver still ON, it starts vibrating until it turns OFF. If I turn the rx OFF first, the radio then shuts down normally. This happens only with the multi module, and not with the DJT. Perhaps it could be related to inverting COM1?? I can make a video of it if you want..
Thanks
João