openrcforums

Hi Guys,

If anyone can point me into the right direction please do so, my rain stopped functioning and I'm drawing blanks.

My previous setup was a FlySky 9X with 9Xtreme board and DJT module.
It was connected to a D4R-II and working just fine.

I've build a new quadcopter and figured I'd upgrade to a XJT module with a X4R-SB receiver.

Now, I press the FS button and power my transmitter, it start beeping and LED's indicate it's binding.
I head over to my quad, press the FS button and power the quad, the receiver keeps having a red and green LED, no blinking.
It's no binding what so ever.

My question, could this be the settings on my transmitter?

I'm unsure what settings I should use for und the "Protocol" settings.
For the D4R-II I used PPM 8ch, which still works fine.
I was able to bind the XJT to the D4X-II and everythign works great.

I want to use SBUS (16ch) with the XJT and X4R-SB combo, what settings would i normally use?
PXX type D16?

I know the following is not 9xtreme related but if anyone knows, could the firmware on my X4R-SB be the problem?

Br,
Fint

Try tuning on the Rx on binding mode first then the Tx


Sent from my iPhone using Tapatalk

On the Tx yes, use PXX and D16. Also, there is a BIND option on that menu to use rather than pressing the button on the back of the module. Power the Rx with the button pressed, then select the BIND option on the Tx.

Mike.

Tried both, no binding.
Thanks for the suggestions guys
Do appriciate it!

Think Im going to look at the rx firmware next, frustration[emoji14]

Could it be the EU firmware problem ?
FrSky X4R-SB - 3/16 Channel Receiver with Sbus and CPPM Downloads: (http://frsky-rc.com/download/index.php? ... pro_id=135)
and XJT (http://frsky-rc.com/download/index.php? ... pro_id=104).
Was the XJT and the X4R-SB purchased, in EU or US ?

Bob B.

i'm having the same problem binding xjt to the x4r-sb now i purchased both the xjt module and x4r-sb Rx in the us now i didn't upgrade no firmware tried binding straight from pacage now i have a flysky fs-th9x up graded to 9xtreme /ersky9x i had the dht module in the tx and d4r-ii works fine now i want to switch over to sbus put the xjt in the tx now in the protocol tab on tx i have internal on proto pxx rxnum 2 type d16 country ame 1st chan 1 then theres bind and then range check no i setup the x4r-sb to naze32 rev afro flight now power on tx go to protocol tab go down to bind press bind power up rx the light goes from flashing red to green but its like therses no signal in cleanflight rx tab i'm not getting no stick movements any help would be well appreciated.

i figure it out it was the settings in my Tx .

moxieman3864 wrote: ↑Fri Oct 14, 2016 1:31 am i figure it out it was the settings in my Tx .

What settings are those you mentioned?
I'm having the same issue even though I have the latest EU-LBT Firmwares.

Best Regards,
CubriC