Page 1 of 1
How to make switch that overrides multiple channels?
Posted: Tue Apr 05, 2016 10:41 pm
I want to make a switch that puts the OSD into edit mode. Which is Throttle middle, yaw right, pitch full. How can I make a switch that does this?
Re: How to make switch that overrides multiple channels?
Posted: Tue Apr 05, 2016 11:19 pm
For any channel you may add a mix line at the end of the mixes for that channel. Make it of type "Replace", the source = FULL, the weight the output value you require and the switch whatever switch you want to set the channel to this value.
So if on your yaw channel you probably have a mix like:
R +100% FULL switch(RUD)
on that channel
Another way would be to use a Safety switch to provide the override.