How to make switch that overrides multiple channels?

ersky9xr is the port of the er9x firmware to the 9XRPRO radio.
Post Reply
CptanPanic
Posts: 25
Joined: Tue Mar 22, 2016 12:32 am
Country: -

How to make switch that overrides multiple channels?

Post by CptanPanic »

I want to make a switch that puts the OSD into edit mode. Which is Throttle middle, yaw right, pitch full. How can I make a switch that does this?

Thanks,
CP

User avatar
MikeB
9x Developer
Posts: 17990
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: How to make switch that overrides multiple channels?

Post by MikeB »

For any channel you may add a mix line at the end of the mixes for that channel. Make it of type "Replace", the source = FULL, the weight the output value you require and the switch whatever switch you want to set the channel to this value.

So if on your yaw channel you probably have a mix like:
+100% Rud
Simply add:
R +100% FULL switch(RUD)
on that channel

Another way would be to use a Safety switch to provide the override.

Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
Post Reply

Return to “ersky9xr”