Hello, I am lost...
After reading all I found on setting up the 9XR Pro with a Sim, I am still getting only basic 4 channels with the MPX Multiflight (based on XTR sim).
My radio is with r218 code, Mode2, channel assignment AETR.
I am using the HK 12in1 USB interface, switch set for XTR mode. I have not set up any of those copies of cracked flightsims that come with the USB dongle so I cannot tell if this is a sim thing, as I hate cracked SW by a rule... For a bought flight sim, I have an Aerofly 5 with a controller that is bound to it (and the aerofly sim will not start with the USB dongle plugged in, I guess some crack protection there.
As I have built a new FunCub XL, I have downloaded the free Multiplex Multiflight simulator from www.multiplex-rc.de
. However, it recognizes only the basic four channels, so unable to use flaps, for example.
I have tried to set up different switches and pots on different channels, 5-16, using HALF, FULL, curves, whatever I thought could be used, and I still have no response from these using whatever I try.
Protocol: PPM, start channel 1 (I have tried Follow as well, only mixes up the channels differently); PPM2 channels 8 (I have tried 6, 16 as well); protocol PPM, Opendrain, I have tried to use both POS and NEG in the Shift Sel, no avail...
What puzzles me as well is that the channels appear to be mixed up in the sim:
RADIO ch SIM shows as
AIL 1 2
ELE 2 1
THR 3 6
RUD 4 3
...so ch 4 seems to be not used on the sim... I have done the radio calibration in the sim and the channel assignment many times, am able to control the basic 4 channels correctly, but unable to set up whichever channel as channel 5 to use flaps... I would so much love to learn fly the Funcub XL in the sim before going live... (same issue with other models in the same sim).
anyone has an idea what to do and test? Would anyone have an idea what could be the reason? Anyone using the MPX Multiflight?
thank you, regrads, redear