Page 1 of 1
Control differential ailerons with a pot
Posted: Tue Jul 07, 2020 9:15 am
by tetramonium
Hi
Is there a simple way to control differential on ailerons with a potentiometer
Thank you
Re: Control differential ailerons with a pot
Posted: Tue Jul 07, 2020 10:53 am
by jhsa
The answer to your question is, there is probably a simple way, but we need more information please.. What exactly do you want to do?
Simple is relative by the way
What is simple for me might not be for you
João
Re: Control differential ailerons with a pot
Posted: Tue Jul 07, 2020 12:24 pm
by tetramonium
I want to use a pot to adjust differential ailerons
Is there a way to adjust the diff val with a pot?
Sorry for my bad english and thanks for answer
Christophe
Edit perhaps it's important it's for flying wing
Edit 2 not sure but I think I want to do something like
here
I try this but doesn't work correctly
Edit 3 sorry the exemple
here seem work
Thank again for answer
Christophe
Re: Control differential ailerons with a pot
Posted: Tue Jul 07, 2020 1:44 pm
by jhsa
So, the last example worked for you? did you try it?
João
Re: Control differential ailerons with a pot
Posted: Tue Jul 07, 2020 1:48 pm
by tetramonium
Yes seems to work
Thank you again
Christophe
Re: Control differential ailerons with a pot
Posted: Tue Jul 07, 2020 2:27 pm
by jhsa
Nice that you found it.. Well done
João
Re: Control differential ailerons with a pot
Posted: Tue Jul 07, 2020 2:30 pm
by MikeB
Mixes do have an option to use "Diff" (for differential) instead of a curve or expo. If you select "Diff", you then normally set a value, but you may also use a Gvar (Global variable). If you use a Gvar, you may set the Gvar source to be a pot. I'll hopefully post an example of doing this later today.
Mike