NO SIGNAL to receiver - 9XR Pro W/ FrSky XJT - HELP!
Posted: Tue Feb 05, 2019 1:27 pm
Hello all,
I'm totally new here. I previously ran an old Spektrum Radio so the 9XR Pro is completely new to me. I'm using it for combat robots, and am having problems with getting a signal to the receiver.
I've bound the module to a X4R receiver - confirmed by green LED as soon as Tx is powered on. The problem is when I apply throttle or ail/ele nothing happens at all. I'm using Ail/Ele for drive (two motors/esc's) and throttle for a third motor powering a spinning weapon. I've tried Channels 1 thru 3 on the receiver....nothing.
I then bound it to my X8R Rx to see if it was a receiver problem. Again bound great but once again no signal at all when I move the sticks on the Tx with my esc's plugged into any of the channels.
I have no clue what could be wrong at this point. I bought the Tx and Module about 6 months ago. The two switches on the back of the module are both down which is what the manual stated for X series receivers.
Any help is greatly appreciated!
I'm totally new here. I previously ran an old Spektrum Radio so the 9XR Pro is completely new to me. I'm using it for combat robots, and am having problems with getting a signal to the receiver.
I've bound the module to a X4R receiver - confirmed by green LED as soon as Tx is powered on. The problem is when I apply throttle or ail/ele nothing happens at all. I'm using Ail/Ele for drive (two motors/esc's) and throttle for a third motor powering a spinning weapon. I've tried Channels 1 thru 3 on the receiver....nothing.
I then bound it to my X8R Rx to see if it was a receiver problem. Again bound great but once again no signal at all when I move the sticks on the Tx with my esc's plugged into any of the channels.
I have no clue what could be wrong at this point. I bought the Tx and Module about 6 months ago. The two switches on the back of the module are both down which is what the manual stated for X series receivers.
Any help is greatly appreciated!