9xr-pro+x4rsb+runcam-remote-cable+kissFC

ersky9xr is the port of the er9x firmware to the 9XRPRO radio.
Post Reply
wesk18
Posts: 5
Joined: Wed Feb 22, 2017 4:50 pm
Country: -

9xr-pro+x4rsb+runcam-remote-cable+kissFC

Post by wesk18 » Wed May 03, 2017 6:09 pm

Hello all,

I'm running latest firmware 9xr-pro from mike, with banggood multiprotocol tx to a x4rsb on a kissFC, im trying to hook up a runcam remote cable, so far I did the ch2+3 jumper thing before binding, I connected the remote cable to pins channel 1(not sure if I can use those pins should I be using ch 2 pins?), how to configure the 9xr-pro to control this remote cable? ch 5?

Regards

Robert

update: I think I know what's the problem, I'm running wifi on, I saw on a video it has to be turned off.


komos
Posts: 19
Joined: Tue Dec 13, 2016 1:51 pm
Country: -

Re: 9xr-pro+x4rsb+runcam-remote-cable+kissFC

Post by komos » Wed May 03, 2017 7:41 pm

I think you can get only channels 1-3 from convetional channel outputs. what does the jumper do in the binding procedure? i think this is not supported on x4rsb. X8R maybe. At least nothing is stated on x4rsb manual.
So now what?
solution one is get an sbus decoder and use channel 5 from there.
solution two (unsure if its doable) is to assign channels 2-5 for T A E R on the Kiss FC and then use chanel 1 from convetional output for camera remote

User avatar
Kilrah
Posts: 10795
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: 9xr-pro+x4rsb+runcam-remote-cable+kissFC

Post by Kilrah » Wed May 03, 2017 8:19 pm

When binding with the jumpers CH1 is PPM so you don't want that, CH2 is CH9 and CH3 is CH10.

Needs recent X4R firmware, and it all IS in the current manual.

wesk18
Posts: 5
Joined: Wed Feb 22, 2017 4:50 pm
Country: -

Re: 9xr-pro+x4rsb+runcam-remote-cable+kissFC

Post by wesk18 » Wed Jun 14, 2017 12:35 am

Hello,

I got this resolved, had it in the wrong channel.
thanks


Post Reply

Return to “ersky9xr”