Problem Telemetry 9XR PRO+X8R+NAZE32

Hardware Support for the 9XR Pro
Post Reply
GhostSharp
Posts: 9
Joined: Thu Apr 09, 2015 8:18 am
Country: -

Problem Telemetry 9XR PRO+X8R+NAZE32

Post by GhostSharp » Fri Dec 18, 2015 1:36 pm

Hi,

I have connected X8R by SBUS to NAZE32 and fine with a bit problem of left gimbal stick. But i can't to get telemetry using 5rx-6tx pins softserial naze32 connected to signal pin of smarport of X8R. I only got RSSI parameter but no more.

Is neccesary special firmware or special configuration for work it?

Thanks.


User avatar
Kilrah
Posts: 10606
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Problem Telemetry 9XR PRO+X8R+NAZE32

Post by Kilrah » Fri Dec 18, 2015 2:55 pm

Not on the radio apart from running a new sensor discovery if you're on 2.1, but on the Naze yes there are a few parameters to set up.

GhostSharp
Posts: 9
Joined: Thu Apr 09, 2015 8:18 am
Country: -

Re: Problem Telemetry 9XR PRO+X8R+NAZE32

Post by GhostSharp » Wed Dec 30, 2015 2:30 pm

Thanks Kilrah,

After going crazy a long time, I managed to get some parameters activating "Protocol PXX D16" and disconnecting the cable between the module XJT (RX / TX) and port Futaba (trainer COM2).

I added the GPS coordinates naze32 to have and there seems to conflict using "investment telemetry ON" and GPS.

I will continue investigating ...

Thanks for all.


Post Reply

Return to “Turnigy 9XR PRO radio”