openrcforums

9XR Pro can not active Trainer mode one some model......

I have this Turnigy 9XR Pro using ersky9X-r221

The Trainer mode works perfectly on SYMA X5C drone but When I switch to other model that use FRSKY receiver, the Trainer Mode do not work.

but I can see all those 4 no. (Aileron, Elevator,Throttle and Rudder) on the Trainer menu while I move the Slave transmitter.

I have check all the setting of Trainer menu setting between Syma model and FRsky model its all the same.

have also tried different Switch for activating the Trainer mode, have tried Gear switch......it did not work.

Been thinking there might be some Bugs on the firmware of the transmitter...

ersky9x supports 4 trainer "profiles", to allow for different student transmitters and different methods of receiving the trainer signal.
In the MODEL|PROTOCOL|TRAINER menu, there is a setting to select which profile to use, or OFF to use non of them.
Make sure this is set to the profile you wish to use. In the RADIO|TRAINER menu, you may give a name to each of the profiles and this will appear in the MODEL|PROTOCOL|TRAINER menu.

Mike

Nope, no bugs, I use all sorts of trainer options in ersky9x , including bluetooth and SBUS, and all works.

If you see the trainer inputs moving in the trainer menu, it means the radio is receiving the trainer information.
So it must be something with your settings.

João

Sent from my BLN-L21 using Tapatalk

Mike,

able to make it work and play with different profile of training mode......Thanks

Joao,

yes.....maybe I can use one of my Frsky Receiver set it to PPM mode and make a Male Phone Jack......its a wireless Training ..... Thanks

You should find the "last" trainer source option is "JACK SBUS". This allows you to use a receiver that outputs SBUS as a wireless trainer and just connect the SBUS output to the jack socket.

Mike

I have built a few very small DIY Frsky D8 compatible receivers, that just output SBUS, and installed them inside my radios..

João