Page 1 of 1
4th pot
Posted: Mon Jan 21, 2019 5:36 pm
by antlerhanger
So I need a 4th pot on my 9x pro .I have used the spare dig for a 3way switch . Can I use the spare ana for the fourth pot ? And how ? I have installed the encoder and it works great (Thanks so much for the help on that)
Thanks
Allen
Re: 4th pot
Posted: Tue Jan 22, 2019 3:50 pm
by MikeB
Yes, the spare ANA input is on J3. pin 2. Analog 3.3V is on J3 pin 1, and ground is on J3 pin 5.
For a pot, you will need to remove R83 and R90 (both 2K2) as these provide a potential divider so the signal could be used as a 3-pos switch input. Also make sure R22 (100R) is present, or solder a wire across it.
Wire up the pot, then go to the Hardware menu and set pot 4 to AD10.
Mike
Re: 4th pot
Posted: Tue Jan 22, 2019 6:05 pm
by antlerhanger
Thank you so much . You my friend , are amazing !! .
Allen