7-way Rotary Encoder

Hardware Support for the 9XR Pro
Post Reply
rcInky
Posts: 7
Joined: Tue Aug 21, 2018 8:54 am
Country: -

7-way Rotary Encoder

Post by rcInky » Sun Aug 08, 2021 3:17 am

Hi,

I'm thinking of replacing the four select buttons on my 9XR Pro with a rotary switch same as used to be done on the 9X.
Is it possible to wire all seven switch functions as it was on the 9X or are only the rotary switch functions through J1B available?
I have the v.1.1 board.

Cheers,
David
Attachments
20150915_164615_preview_featured.jpg
20150915_164615_preview_featured.jpg (113.15 KiB) Viewed 530 times
Rotary.png
(760.4 KiB) Not downloaded yet


User avatar
MikeB
9x Developer
Posts: 17543
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: 7-way Rotary Encoder

Post by MikeB » Thu Aug 12, 2021 8:35 am

Yes, the 4 direction switches should wire in to the existing 4 direction buttons, and the encoder and centre button wire in as well.

Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

rcInky
Posts: 7
Joined: Tue Aug 21, 2018 8:54 am
Country: -

Re: 7-way Rotary Encoder

Post by rcInky » Thu Aug 19, 2021 6:44 am

Thanks for the response Mike,

I've been away hence the slow reply.
So it's solder fly leads to the PCB. I couldn't see any headers that seemed relevant but wanted to check to be sure.


Cheers,
David

User avatar
MikeB
9x Developer
Posts: 17543
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: 7-way Rotary Encoder

Post by MikeB » Thu Aug 19, 2021 2:09 pm

Yes, solder 4, fly-leads to the PCB.

Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!


Post Reply

Return to “Turnigy 9XR PRO radio”