915 mhz orange rx

OpenLRSng runs on a number of different platforms. Find out more / post your questions here.

Moderator: kha

Post Reply
Posts: 2
Joined: Wed Feb 06, 2019 12:15 pm
Country: -

915 mhz orange rx

Post by jongillioz » Wed Feb 06, 2019 12:36 pm

Hi all i have flashed the new hobbyking orange rx tx and rx . the ones that only have ppm and a serial port for telemetry back .
i used an isp programmer to flash the rx as it had no bootloader. have connected the tx using serial to configurator and seems ho have the correct flash on it
i cant seem to bind the tx to the rx . i had the rx serial port pluged in to a ftdi cable and can see it boot and gets to a point it sais it has bad eeprom or bind button is pressed and waiting to bind but it never seems to bind. any ideas what i did wrong :?: . i did flash the 915 mhz

regards jon

Posts: 1
Joined: Wed May 08, 2019 9:42 pm
Country: -

Re: 915 mhz orange rx

Post by vk4dz » Wed May 08, 2019 10:23 pm

G'day all,

I have the same problem with the 915MHz ones. Did everything the same as Jon except for watching the serial port. Everything is alive but refuses to bind.

Have you come up with any answers Jon? or anybody else?

I grabbed these cheap from HK when I realised the 433's I previously bought would be somewhat limited due to regulatory issues.


Post Reply

Return to “OpenLRSng hardware”