Range Problem, 9x, dtf uhf tx, dtf uhf rx

Support and help for the OpenLRSng project.

Moderator: kha

Post Reply
Posts: 1
Joined: Fri Mar 18, 2016 5:24 pm
Country: -

Range Problem, 9x, dtf uhf tx, dtf uhf rx

Post by musicguy2112 »


Just got my TX and RX hardware this week and set up everything. Here is what I got:

DTF UHF 1-watt Deluxe TX JR Module 433 MHZ
https://www.multirotorsuperstore.com/dt ... odule.html

Diamond SRH-771 UHF Antenna
https://www.multirotorsuperstore.com/di ... tenna.html

Brotronics 4ch Remix Rx, 433 MHZ
https://www.multirotorsuperstore.com/br ... remix.html

1/4 Mono UHF Rx Antenna
https://www.multirotorsuperstore.com/1- ... tenna.html

So I programmed the TX through The chrome app without any problems, of course always with the antenna attached. Was able to bind, but my problem is I cannot go further than about 50 meters. The TX starts beeping as my copter goes further. Si my pixhawk controller has it programmed for a radio failsafe and returns to launch. My TX is programmed for 500mw, I tried 1 Watt and I still have the same thing. If anyone has some tips for me or if there is an obvious thing I am doing wrong?

Thanks in Advance!

Post Reply

Return to “OpenLRSng”