Can't Bind

Everything about the smartie programmer and backlight kit!
Kdaffy
Posts: 46
Joined: Fri Mar 04, 2016 1:23 pm
Country: Greece
Location: Athens

Re: Can't Bind

Post by Kdaffy » Mon Aug 08, 2016 8:04 pm

The leds on ths DJT and receiver were EXACTLY as you drscribed.
It


Στάλθηκε από το Redmi Note 3 μου χρησιμοποιώντας Tapatalk

User avatar
MikeB
9x Developer
Posts: 15801
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: Can't Bind

Post by MikeB » Mon Aug 08, 2016 9:16 pm

Do you have any servos to plug into the receiver normally?

Mike.
ersky9x/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

Kdaffy
Posts: 46
Joined: Fri Mar 04, 2016 1:23 pm
Country: Greece
Location: Athens

Re: Can't Bind

Post by Kdaffy » Tue Aug 09, 2016 5:42 am

I have the cables from the tarot fc to the receiver but the camera is pluged directly to rx

Στάλθηκε από το Redmi Note 3 μου χρησιμοποιώντας Tapatalk

Kdaffy
Posts: 46
Joined: Fri Mar 04, 2016 1:23 pm
Country: Greece
Location: Athens

Re: Can't Bind

Post by Kdaffy » Tue Aug 09, 2016 4:55 pm

I unscrewed the smartieparts board and i saw something wrong. A cable from the board was cut. I solder it but still nothing. The board doesn't seem to have a problem. And now I'm not sure if i took out the DJT with the tx switched on at the first place. Something else is wrong.

Στάλθηκε από το Redmi Note 3 μου χρησιμοποιώντας Tapatalk

Kdaffy
Posts: 46
Joined: Fri Mar 04, 2016 1:23 pm
Country: Greece
Location: Athens

Re: Can't Bind

Post by Kdaffy » Tue Aug 09, 2016 4:55 pm

Image

Στάλθηκε από το Redmi Note 3 μου χρησιμοποιώντας Tapatalk


Kdaffy
Posts: 46
Joined: Fri Mar 04, 2016 1:23 pm
Country: Greece
Location: Athens

Re: Can't Bind

Post by Kdaffy » Tue Aug 09, 2016 4:57 pm

The cut cable seemed like it got hot and cut from the board.

Στάλθηκε από το Redmi Note 3 μου χρησιμοποιώντας Tapatalk

Post Reply

Return to “SMARTIEPARTS PROGRAMMER”