Page 1 of 1

SP basic rev 1.1

Posted: Sun Jun 18, 2017 3:01 pm
by achilo

I would like to ask if there is anywhere tutorial how to use SP basic rev 1.1 programmer for flash of Turnigy 9X to ER9X firmware? I can't find straight guide how to do it and not shure if it't tha same procedure like with 9Xtreme board.

thank you

Re: SP basic rev 1.1

Posted: Sun Jun 18, 2017 3:40 pm
by jhsa
It's not the same Procedure..
Did you try searching the "Smartieparts" website? They should have all the information you need there..


Sent from my thor using Tapatalk

Re: SP basic rev 1.1

Posted: Sun Jun 18, 2017 3:45 pm
by s_mack
The Spbasic is just a purpose built usbasp programmer, so any tutorial on flashing firmware to your 9x is relevant. I'm sorry, I'm on the road now, otherwise I would post a link to one. But Google "how to flash er9x" (or opentx).

Re: SP basic rev 1.1

Posted: Tue Jun 20, 2017 6:43 pm
by achilo
@ jhsa: Smartieparts website describe only hardware instalation, with this I'm ok. I'm mainly focused now to the software part. If I can just taky any tutorial using eepe and correct firmware version.

@ s_mack: when you have time please post some link for me . Thank you. Meanwhile I will google how to flash it . I just don't want to brick something.