Jumper wires?

Everything about the smartie programmer and backlight kit!
Post Reply
citfta
Posts: 22
Joined: Sat Nov 22, 2014 12:53 am
Country: -

Jumper wires?

Post by citfta » Mon Feb 17, 2020 9:24 pm

This may be the wrong place to ask this but I found some jumpers when looking at a mod done to my transmitter before I got it. It has a Smartieparts board rev 2.1 installed and a Sparkfun board as an interface between the hardwire FrSky DHT module and the Smartieparts board. I was reading the installation instructions for the Smartiepart board and it says nothing about having to install any jumper wires unless you have a Rev one 9X board that has one of the contact pads in the wrong place but that doesn't seem to be what I have. I have included a picture of the jumper wires. You can see they seem to run from just under the edge of the Smartieparts near the left side of the board and then they go very close to the edge of the SP board near the top center of the board. Does anyone have any idea what they are for? Or what they do?

Carroll
Attachments
9x jumper wires.jpg


Post Reply

Return to “SMARTIEPARTS PROGRAMMER”