USBASP 6 pin question

Post Reply
Posts: 1
Joined: Fri Feb 07, 2014 6:12 pm
Country: -

USBASP 6 pin question

Post by Flingwinger » Fri Feb 07, 2014 6:24 pm


This is my first post to openrcforums though I have browsed it quite a bit through my learning of programming with ER9x. I have a question on the programmer from 9xrprogrammer from rperkins. I was very happy to get it very quickly and I am a couple of minutes from pulling out the soldering iron and starting my long awaited flash of my 9x but I am unsure which side of the ribbon is wire number 1 and which is wire 6 when looking at the USB and ribbon from the top. Is the left side the # 1 cable when viewed from above? Any help would be greatly appreciated as for I don't want to mess this up. Thank you in advance.

Also, would this be correct for the 6 pin?

Pin 1=MOSI
Pin 2=+5v VCC
Pin 3=Reset
Pin 4=SCK
Pin 5=MISO
Pin 6=Ground

User avatar
Posts: 1422
Joined: Sun Jan 08, 2012 12:51 pm
Country: -

Re: USBASP 6 pin question

Post by rperkins » Fri Feb 07, 2014 8:38 pm


Here is a pic that shows the pinouts as if you were looking into the socket on the small board ... p-hardware

I took that pic and reversed it so it shows the cable end also
Hope this helps and good luck. let me know if you need any more assistance

Post Reply