RSSI - send value to FC OSD via SBUS

Post Reply
lancaster
Posts: 206
Joined: Thu Jun 12, 2014 10:28 pm
Country: United Kingdom

RSSI - send value to FC OSD via SBUS

Post by lancaster »

Hi Guys
I have been following the youtube video (https://www.youtube.com/watch?v=nZxMvTCN_pI) showing how this can be done with Open TX

ie send the RSSI value back to TX via telemetry return it to the RX via 2.4Ghz then through to the FC and OSD via SBUS

Open TX provides an inputs page to source RSSI but I can find the equivalent step in ErSky9X - is this possible?

I'm using the 9Xtreme with an X6R and the Omnibus F4 flight controller

regards
Hans

User avatar
MikeB
9x Developer
Posts: 17990
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: RSSI - send value to FC OSD via SBUS

Post by MikeB »

Yes!
Use a Scaler. Set the source to RSSI and the multiplier to 10, then use the scaler as the source to a channel mix.
That will get the RSSI value controlling the channel, then you should be able to follow the video instructions to use the channel.

Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
lancaster
Posts: 206
Joined: Thu Jun 12, 2014 10:28 pm
Country: United Kingdom

Re: RSSI - send value to FC OSD via SBUS

Post by lancaster »

Hi Mike
Amazingly rapid response - whats more its positive - ErSky9x provides the answer again
Great work Mike
I'll follow your instructions
Many many thanks
Hans
User avatar
MikeB
9x Developer
Posts: 17990
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: RSSI - send value to FC OSD via SBUS

Post by MikeB »

More due to luck! I just happened to look at the forum having been out most of the day. I didn't notice the time of your post, I was just looking at all posts through the day.

Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!

Post Reply

Return to “ersky9x model setup”