Trims not working as expected

Post Reply
farlinoff
Posts: 19
Joined: Tue Sep 23, 2014 1:13 pm
Country: -

Trims not working as expected

Post by farlinoff » Thu Dec 18, 2014 7:00 am

Hi, I am using er9x, SVN: er9x-r813, VERS: V1.275-Mike and recently noticed that the trims on my Tx are not working as expected.

My Tx is Mode 1 and the er9x mix settings are CH1: +100%RUD, Ch2: +100%ELE, CH3: +100%THR, CH4: +100%AIL

This all works perfectly with my Rx which has Ch1: connected to Aileron servo, Ch2: connected to Elevevator servo, Ch3: connected to Throttle ESC and Ch4: connected to rudder servo.

However, when I use the rudder trim, located below the left stick on my Tx, the aileron setting is trimmed and when I use the aileron trim, located below the right stick on my Tx, the rudder setting is trimmed?

This is extremely confusing and is not what I would expect. Any help would be appreciated.

Regards

Trevor


farlinoff
Posts: 19
Joined: Tue Sep 23, 2014 1:13 pm
Country: -

Re: Trims not working as expected

Post by farlinoff » Thu Dec 18, 2014 7:46 am

Hi, I am replying to my own question. I discovered that I had the CrossTrim setting set to ON in the Txs SETTINGS / Controls menu. Turning that OFF solved the problem The flexibility of er9x is amazing but can be full of traps for new players like myself.

Regards,

Trevor

Post Reply

Return to “er9x model setup”