My Transmitter is a 9 XRPro
My receiver FrSky D4R-II
My receiver seems to bind ; red light flashes and green light on
Receiver is connected to battery.
When I move sticks on my transmitter nothing happens.
receiver is set; AETR1234, RSI Channel 8
(Channel 3 and Channel 4 connected by jumper/Channel2 outputs RSSI)
simple Mixes are set on the transmitter.
Computer is connected to NAZE 32 flight controller
When I open the receiver page in my GCS (Cleanflight) I see nothing happen(except two running lines).
Why is my transmitter not functionning??
motors arm in Cleanflight GCS not with transmitter
Re: motors arm in Cleanflight GCS not with transmitter
Maybe wrong conneciton between receiver and FC, maybe wrong receiver type selected in FC, many possibilites, need more details...
Re: motors arm in Cleanflight GCS not with transmitter
THAT "information" ist NOT helpful.litse23 wrote:When I open the receiver page in my GCS (Cleanflight) I see nothing happen(except two running lines).
Why is my transmitter not functionning??
Start with that here. Get an oscilloscope and verify, that signals are send from your rx to the fc.
If you don't have a an oscilloscope, there are simple test devices, you can build yourself for ~$10, to check that.
-> viewtopic.php?f=84&t=4549
You have to find out, where the problem is ...
- rx not sending signals (see above ...)
- bad connection to fc (check cable and read cleanflight documentation for connection)
- wrong setup of fc (read cleanflight documentation)
- fc bad (finally if points above are all ok, get another fc)
You have to check and verify those points.
And please, give REAL information, so one can give a hand!
br KH
Re: motors arm in Cleanflight GCS not with transmitter
Thanks for every information.
I go further to work wth it....
Herman
I go further to work wth it....
Herman